How To Adjust The Speed Of DC Motor

Speed can reflect our explosive power, people with good speed are naturally good in all aspects of physical fitness. For DC motors, the right speed is very helpful for our use and our work, then how do we adjust A suitable speed?

1. Disconnect the power, open the box, loosen the cover screws, and remove the cover.

2. Use a hex wrench to adjust each of the tension spring screws to achieve the best results when the DC motor controller is running.

3. If the starting time rod is shaken, it means that the tension of the balance spring is too large, repeat the above operation.

4. Connect the channel gate power supply, press the up or down button of the controller to let the DC motor controller run up and down 90 degrees 4 to 5 times. If the falling rod time bar appears jittery, it means that the balance spring tension is not enough, the DC motor controller Run to the vertical state.

5. When starting the pole, if the DC motor controller is running and the DC motor controller does not work, it indicates that the balance tension spring is insufficient, adjust the tension spring state or increase the tension spring until the DC motor controller runs normally.

Therefore, according to the actual situation, the DC motor should be adjusted differently. All should be based on reality. We must learn flexible work and flexible change of ideas to achieve the purpose we want.