DC Gear Motor With Encoder TT Motor DC5V

DC Gear Motor With Encoder TT Motor DC5V

Product Description: Precision metal gears: Enhanced bearing capacity. wear-resistant type. prolonging the service life. Ensure the bearing capacity under high torque. ABS material: Environmentally friendly and durable without rusting to extend the service life. Dual D-type output structure:...
Send Inquiry

Product Description:

Brand CHIHAI MOTOR
Product Type CHF-130T ABHL DC Gear Motor With Encoder TT Motor
Shaft Length 8.5mm
Shaft Dianeter φ 5.5mm
Voltage DC 5V
Weight About 53g
reduction ratio 1: 48,1: 90
Wiring specification PH2.0-6PIN terminal connector
Encoder Specification A B dual phase encoder, 6 line basic signal voltage 3.3V or 5.0V
Application There are scientific research electronic products, robot electric body class, bubble gun play Guns, four-wheel drive toys and cars, aircraft toys Vibration products such as electric toy products.

 

 

Precision metal gears:

Enhanced bearing capacity. wear-resistant type. prolonging the service life. Ensure the bearing capacity under high torque.

 

ABS material:

Environmentally friendly and durable without rusting to extend the service life.

 

Dual D-type output structure:

With threaded hole in the centre. Suitable for TT motor accessories on the market today.

 

The system employs dual Hall sensors to generate 90-degree phase-shifted waveforms.

Automotive-grade components ensure enhanced reliability, and the encoder is safeguarded by a concealed design.

 

AB dual phase incremental encoder:

Basic pulse 6PPR X gear reduction ratio

 

An encoder is like a little pulse generator at the back of the motor, tracking how fast it spins.

The AB phase encoder is even cooler - it pumps out two sets of pulses that are 90 degrees out of sync.

This setup not only boosts our measuring precision but also helps us figure out which way the motor's turning.

 

 

Detailed Images:

130T03

130T04

 

Note: 1.The voltage between V-G is set based on the microcontroller's power supply, typically 3.3V or 5V.

2.The frequency of the square wave from H1 and H2 is influenced by the motor speed and the pole count of the magnetic disc.

3.The voltage between M+ and M- is determined by the motor's operating voltage.

130T05

Working principle:

1,Motor speed measurement: The Hall sensor detects the N and S poles of the magnetic disc. We're using the type that senses the S pole. So, every time the Hall sensor picks up the S pole of the disc, it sends out a high-level signal at the output; it sends a low-level signal when it senses the N pole. As the motor turns, the Hall sensor outputs a square wave. By measuring the period T of this square wave, we can determine the motor speed. Let's say our magnetic disc has P poles, and we measure the square wave period as T. The formula to calculate motor speed is: n = 60 / PT

 

2.,Detecting motor direction: We've got two Hall sensors positioned at different spots in the circuit. Depending on whether the motor's spinning forward or backward, these sensors produce different square waves.

 

When the motor's going forward, H1 spots a rising edge, and right after, H2 sees a falling one. But when it's reversing, H1 catches a falling edge, and then H2 does the same.

130T07

130T08

130T09

130T10

130T11

130T12

130T13

130T14

Hot Tags: dc gear motor with encoder tt motor dc5v, China, manufacturers, factory, customized, wholesale, bulk, in stock, Gear Reduction Motor With Encoder

Previous:No Information

Send Inquiry